LABVIEW TEKTRONIX OSCILLOSCOPE DRIVER

In the NI driver for scope to set the timebase “Configure Timebase. Can I connect three or more devices together? Email Required, but never shown. Yes, but you must use a hub in this case. A crossover cable is an RJ cable which lets you plug the two network ports together directly without needing a network hub.

Uploader: Kegrel
Date Added: 27 April 2004
File Size: 10.85 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 23629
Price: Free* [*Free Regsitration Required]

By clicking “Post Your Answer”, you acknowledge that you have read our updated oscillozcope of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies.

Configuring a Tektronix Oscilloscope to Communicate with a Crossover Ethernet Cable

This should bring up a page that looks something like this. How do I make a cross-over Ethernet cable?

Back to Top 3. By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service.

Back to Top 2. Configuring Oscilloscope timebase from labview Ask Question.

LabVIEW Add-On for Tektronix Open Windows Oscilloscopes Version 1.2

This document describes how to set up a computer and Ethernet-based instrument to communicate over a simple Ethernet cross-over cable. A cross-over cable maps the 1,2 pair on each end to 3,6 on the other lscilloscope. In this case, you will use a regular straight-through twisted-pair Ethernet cable to connect each device to the hub. Everything else is the same.

  865A01-PE-6EKRS LAN DRIVER DOWNLOAD

Testing Now we need to verify that we configured everything correctly and that our cable is working okay. Sign up using Email and Password.

Can I connect three or more devices together? This should bring up the window below. These are 8-wire connectors slightly larger than RJ modular phone lscilloscope.

LabVIEW Add-On for Tektronix Open Windows Oscilloscopes Version – National Instruments

Now we need to verify that we configured everything correctly and that our cable is working okay. This simple diagram should return a typical response from the instrument. You should then see a dialog that looks like the image below.

Email Required, but never shown. In the NI driver for scope to set the timebase “Configure Timebase. Yes, but you must use a hub in this case.

Post as a guest Name. Frequently Asked Questions Q1: This site uses cookies to offer you a better browsing experience.

Press OK Accept to apply the changes. A crossover cable is an RJ cable which lets you plug the two network ports together directly without needing a network hub. For those who may have this question, I do have found a way around. In oscilloscpe dialog, we want to turn off Obtain an IP address automaticallyand switch it to Use the following IP address.

  ASUS EEE PC 1015PEM WIRELESS WLAN WIFI DRIVER DOWNLOAD

Press OK on all of these dialogs and return back to Windows.

Configuring Oscilloscope timebase from labview – Stack Overflow

Rate this document Select a Rating 1 – Poor 2 3 4 5 – Excellent. In above calculation, just make sure you do not cross your sampling rate provided by vendor. First, you need to get to the network configuration control panel. Sign up using Facebook. Ashutosh 1 4 For Ethernet, pairs 1 and 2, and 3 and 6 are oscillkscope.